Universidade Fernando Pessoa
Porto, Portugal
Seismic-Sequential Stratigraphy
1) Filling Patterns (cont)
Plate 229 - In offshore Angola, near the mouth of the Congo River, external channel fill patterns were filled by deep-water sediments, which, on NW-SE seismic lines, exhibit a doubly convergent configuration. Such a reflection configuration is not observed in a SE-NW seismic line. Subsequently, one cannot say that this doubly convergentconfiguration is induced by a subsidence change. Actually, in dip seismic lines, roughly parallel to the sediment transportation along the submarine valleys, one can notice the filling is retrogradational, that is to say, it backsteps toward the shelf break. Briefly speaking, as for the reflection terminations, external and internal patterns must be defined on seismic lines parallel to sediment transportation.
Plate 230 - In association with halokinesis, compensatory subsidence can induce seismic intervals with divergent configurations striking in different directions. As illustrated on this seismic line, the development of turtle-back structure (salt induced tectonic inversion), created a stratigraphic interval with quite different divergent configurations. The vergence of the divergent intervals strongly suggests the maximum of compensatory subsidence, i.e., the maximum of salt evacuation.
Plate 231 - In the upper slope of northern offshore Angola, near the mouth of the Congo river, several submarine valleys characterized by channel fill external patterns, show a complex filling. As usually, the designation complex expresses mainly a mixture of all possible types of internal configurations. It is quite difficult to hypothesize the main filling mechanism.
Plate 232 - Meander belts are often taken as instances of internal complex filling configuration. As illustrated on this seismic line, the external channel fill pattern is obvious. In contrary, with exception of the point bar, the internal filling configuration is quite diverse and complex. In such fluvial depositional systems, sedimentation and erosion are interrelated, which creates complicated patterns.
Plate 233 - Chaotic filling configurations are often found in association with glacial deposits, such as the one illustrated on this photograph. The clearness of the external channel fill pattern strongly contrasts with the disorder of the internal filling.
Plate 234 - On this seismic line, from the deep-water Gulf of Mexico, the filling of a submarine valley located between overbank deposits (turbidite levees), can unequivocally be considered as chaotic. It is quite difficult to interpret any kind of filling pattern. In spite of the sharpness of the reflection terminations (truncation), some geologists do not believe that the truncation seismic surface corresponds to an erosional surface (see later).
Plate 235 - On this line, an incised valley was filled by non-marine sediments creating an external channel fill pattern. No pattern is discernible in the filling interval (chaotic filling). The erosion responsible for the channel fill pattern was induced by a relative sea level fall, which, at the same time, destroys the equilibrium profile of the rivers, causing them to incise their beds. The filling of the incised valleys started a new stratigraphic cycle, which continues with the onlap deposition, of transgressive marine sediments.
to continue press
